Can you hook up subs to a factory amp
Car Audio Defined By A Chick
Stereo sounds so much better that it is actually kind of amazing to me. The Infinity subs would be wired to your amp just like any other setup.
You will need a multimeter and a double AA battery with some speaker wire hooked up to it in order to test for for speaker wires and the phase. The stock amp really is not powerful enough nor designed to run the impedance of your MTX. Once you have determined the proper speaker wires for the rear speakers, you can tap into them and hook them up to the line output converter.
Shops, Stores, Distributors, Group Buys without being authorized will see your account terminated. Note that passwords are case-sensitive. The radio stays on, as does the clock and the 12v ports.
Where to get your signal from? For the best viewing experience please update your browser to Google Chrome.
If you just tap into a pair of speaker wires and happen to get some sound, you may not necessarily have positive and negative correct. The only reason its working for you, is because your amp is most likely watt correction, watt LOL PEAK, and like RMS and you are not pushing it anywhere near the limits. The shop that did the installation put a converter and they say that everything is fine.
For this vehicle where would I get the best frequency results from? I replaced the stock speakers and tried to get them amped.
You would need to use the remote turn on lead from your aftermarket radio usually blue with a white stripe and wire that to the amp turn on lead in the car harness. Could this really be the case.
If you have a pair of speaker wires, you will hear the speaker popping or scratching. The car is canbus equipped.
Oh and also, why does my amp shut off only 10 minutes after i start using my system? Easiest way to improve your stock stereo system. I can include pictures if needed.